Load cell simulation in proteus with arduino

Hello Guys, If you want to simulate load cell with Arduino in proteus professional, You can follow the below youtube video. Source code for load cell simulation is also available below. I am using HX711 in proteus to convert load cell analog voltage to digital signal for arduino.

Video Tutorial

Source Code

This is Arduino code that uses the HX711 library to interface with a load cell sensor. The code initializes the scale by setting the DOUT and SCK pin numbers and then performs a series of readings, including raw readings, average readings, and readings with tare weight and scale factor applied. The code then enters into a loop where it continuously prints the weight in kilograms every 5 seconds.